Asko Refrigerator E6 Error: Condenser fan fault
Asko refrigerator E6 error is a common issue reported by Asko appliance owners. What Asko Refrigerator Error Code E6 Means Error code E6 on an Asko refrigerator indicates a fault with the condenser fan motor. The condenser fan sits near the compressor at the back or base of the unit and draws air over the […]
No
DIY Fixable
From $180
Typical Repair Cost
60-120 min
Pro Repair Time
Quick Assessment
Answer to continue safely
Is it safe to keep using?
No. Continued use without the condenser fan will cause the compressor to overheat and sustain permanent damage. Stop using the unit and arrange repair promptly.
Can I reset the code?
No. E6 requires the condenser fan to be cleaned, unblocked, or replaced before the fault will clear.
When to stop immediately?
Stop if you notice: The compressor is too hot to touch for more than a second — thermal damage is imminent., Temperatures in the fridge compartment have risen above 8 °C (46 °F)..
Symptoms You May Notice
Compressor and base of unit excessively hot to touch
Without the condenser fan removing heat, the compressor and condenser coils at the back or bottom of the appliance become very hot — noticeably more than the slight warmth that is normal during operation.
Cooling performance drops gradually over hours
As the compressor overheats, its thermal protection cuts in and reduces run time, causing temperatures inside both compartments to gradually rise over several hours.
Compressor starts and stops more frequently than normal
The compressor thermal overload protector trips repeatedly when the condenser cannot dissipate heat, causing an irregular short-cycling pattern.
E6 shown on the control panel
The control board logs E6 when it detects that the condenser fan is not running or is drawing insufficient current.
Possible Causes
Blocked or seized condenser fan motor
Dust, pet hair, or debris can clog the fan blades or jam the motor shaft, especially on units that have not been cleaned at the rear for several years.
DIY PossibleFailed condenser fan motor
The motor bearings have worn out or windings have failed, preventing the fan from running even when the board sends the correct signal.
DIY PossibleControl board not sending fan signal
A fault on the PCB output circuit for the condenser fan means the motor never receives a run command, requiring board-level repair.
Requires ProfessionalSafe Checks You Can Do
-
1
Clean the condenser fan and coils
Unplug the unit and pull it away from the wall. Use a vacuum cleaner with a brush attachment or a condenser cleaning brush to remove all dust and lint from the condenser coils and the fan blades at the rear or base of the appliance.
This maintenance step is recommended annually to prevent E6 recurring.
Tools required -
2
Spin the condenser fan blade by hand
With the unit unplugged and rear panel removed (if fitted), spin the condenser fan blade. It should rotate freely with minimal resistance. Stiff movement or grinding indicates seized bearings.
Note the part number on the motor label before ordering a replacement. Condenser fan motors for Asko refrigerators start from $35.
-
3
Reseat the fan motor wiring connector
Locate the electrical connector on the condenser fan motor harness and press it firmly home. Restart the unit and confirm the fan is spinning by listening for airflow from the rear.
You can feel airflow from the rear grille with your hand — it should be warm air being expelled when the compressor is running.
When to Call a Professional
Contact a qualified technician if:
- A clean, freely-spinning fan motor that still triggers E6 points to a PCB fault — repair from $150.
- The compressor has already tripped its thermal overload and will not restart — a qualified technician is needed to assess compressor health.
- The condenser coils are bent, leaking refrigerant oil, or show physical damage.
Need Professional Help?
Find qualified technicians in your area for proper diagnostics and repair.
Refrigerator Repair Service Schedule Appointment